BioMin F ProGel

BioMin F ProGel

BioMin F ProGel (Coming soon)

BioMin ProGel

Instructions for Use

BioMinR F ProGel is a topical desensitising gel delivering bio-available calcium, phosphate and fluoride. Helps to protect the teeth and neutralise the effect of acidic challenges in the mouth.

For use under the supervision of a registered dental professional for the indications recommended below.

it will be available only for Dental professionals. 

Description

BioMinR F ProGel is a non-aqueous desensitising preparation containing patented bio-active particles which adhere to the tooth and soft tissue surfaces to provide controlled release of bio-available calcium, phosphate and fluoride for 8-12 hours. This creates an acid resistant fluorapatite deposit to occlude exposed dentine tubules. BioMin ProGel contains no animal derived products nor has it been subjected to any form of animal testing. 

Contraindications

Allergy to any of the listed ingredients

Warnings and Precautions

Keep out of reach of children. Continued tooth pain and sensitivity, typically for more than 14 days, could indicate an inherent problem that needs to be examined by your dental clinician. If irritation occurs discontinue the use of the gel. Do not use if you are allergic to any of the ingredients listed below. In case of contact with eyes wash thoroughly with water.

 

Indications

Treatment of dentine hypersensitivity

Reduction of sensitivity associated with peroxide-based tooth whitening procedures

After professional scaling and root surface debridement

 

DIRECTIONS FOR USE

Dental Practice Application

By custom tray introduction

Clean the tooth surfaces by light air polishing or polishing cup to remove any biofilm

Rinse out the mouth

Wash the tray thoroughly prior to use

Apply a thick (5mm) coating of the gel to the interior surfaces of the tray and place on the upper/ lower teeth

Leave the tray undisturbed in situ for 5 minutes

Remove the tray from mouth and ask the patient to wipe the residual gel around the teeth with tongue for up to 2 minutes. Do not swallow.

Spit out the remaining gel and do not rinse. The longer the contact time of the gel with the tooth, the better the result

The patient should not eat or drink for 30 minutes.

 By non- tray introduction

Clean the tooth surfaces by light air polishing or polishing cup to remove any biofilm

Rinse out the mouth

Apply a thick layer of BioMIn ProGel to the tooth surfaces, particularly those areas exhibiting sensitivity or demineralisation, with an application swab or gloved finger and use suitable sized interdental brushes between the teeth.

Leave the gel in situ for 5 minutes

Ask the patient to wipe the residual gel around the teeth with tongue for up to 2 minutes. Do not swallow

Spit out the remaining gel and do not rinse. The longer the contact time of the gel with the tooth, the better the result

The patient should not eat or drink for 30 minutes.

At Home Application (day and night as recommended by a registered dental professional)

Clean the teeth using BioMin F toothpaste

Apply a generous layer of BioMin ProGel to those teeth suffering from sensitivity or demineralisation by either a clean finger or a cotton swab. Use recommended sizes of interdental brushes to apply the gel between the teeth.

Leave the gel in situ for 5 minutes

Wipe the residual gel around the teeth with the tongue for up to 2 minutes. Do not swallow

Spit out the remaining gel and do not rinse. The longer the contact time of the gel with the tooth, the better the result

Do not eat or drink for 30 minutes

Ingredients

Glycerin, Silica, PEG400, Fluoro Calcium Phospho Silicate, Aroma, Carbomer, Potassium Acesulphame. Contains maximum of 750ppm of available Fluoride when packed.

Flavours

Strawberry or Melon

Storage

Keep out of strong sunlight in a cool, dry, low humidity environment (5-25 degrees Celsius)